Printable clock kit
The gears behind a clock's hands as a kit you can print. The ZIP has one STL per part, an STL of the whole thing assembled, 1:1 cutting sheets (SVG and DXF) and a parts list. Turn the minute hand and the hour hand follows at exactly 1/12.
Parts
- Back plate, 4 mm: press the two rods into the centre and minute-wheel holes
- Cannon pinion (18 teeth) with minute-hand tube, 4 + 30 mm: turns freely on the centre rod; the minute hand presses onto the top of its tube
- Minute wheel (54 teeth), 4 mm: glue to the minute pinion so they turn together on the second rod
- Minute pinion (18 teeth, module 1.2), 6 mm
- Hour wheel (72 teeth, module 1.2) with hour-hand tube, 4 + 18.5 mm: rides on the cannon pinion tube; the hour hand presses onto its tube
- Dial, 2 mm: held by the three pillars; the holes mark the hours
- Hour hand, 2 mm: press onto the hour-wheel tube
- Minute hand, 2 mm: press onto the cannon pinion tube
- Pillar 1, 24 mm: M3 screw through the back plate, pillar and dial
- Pillar 2, 24 mm: M3 screw through the back plate, pillar and dial
- Pillar 3, 24 mm: M3 screw through the back plate, pillar and dial
You'll also need
- 3 mm centre rod, 39 mm long: pressed into the back plate; the cannon pinion turns on it
- 3 mm minute-wheel rod, 16 mm long: pressed into the back plate
- Rods: 3 mm steel rod (or cut-down M3 screws); the gears turn freely on them (bores 3.4 mm).
- 3 × M3 × 35 screw and nut for the pillars
- Print settings: 0.2 mm layers, 3 walls, 20% infill; gears flat on the bed. The tooth play (backlash) is built in.
- Turn the minute hand: the hour hand follows at 1/12 (12 turns of the minute hand = 1 of the hour hand). To run on its own, the centre rod needs turning once an hour by a clock movement or motor.
- Gear centres: 54.00 mm apart; tip diameters 84.0 mm (minute wheel) and 88.8 mm (hour wheel).
How it was checked
Every gear is a true involute gear from the model behind our clock motion work page, and automated tests check this exact kit: each part is a closed solid with the right volume, the two gear pairs mesh without touching at every angle, no other parts collide, and the bores have the clearances listed. Printers differ, so test-print one gear pair before printing the rest.
Tested: every part is a closed solid with the volume its outline and thickness give, nothing collides apart from meshing gears and press fits, the gears mesh with the hour wheel coaxial, and the ZIP holds every part (packages/mechanics/test/assembly.test.ts and packages/mechanics/test/kits.test.ts).
Related: Clock motion work · Anchor escapement · Gear generator